Recent Posts



Yuken : Vane Pump

Vane Pump :

Vane pumps are available in a number of vane configurations including sliding vane (left), flexible vane, swinging vane, rolling vane, and external vane. Vane pumps are noted for their dry priming, ease of maintenance, and good suction characteristics over the life of the pump. Moreover, vanes can usually handle fluid temperatures from -32°C / -25°F to 260°C / 500°F and differential pressures to 15 BAR / 200 PSI (higher for hydraulic vane pumps). Each type of vane pump offers unique advantages. For example, external vane pumps can handle large solids.Flexible vane pumps, on the other hand, can only handle small solids but create good vacuum. Sliding vane pumps can run dry for short periods of time and handle small amounts of vapor.

How Vane Pumps Work :

Despite the different configurations, most vane pumps operate under the same general principle described below.

1. A slotted rotor is eccentrically supported in a cycloidal cam. The rotor is located close to the wall of the cam so a crescent-shaped cavity is formed. The rotor is sealed into the cam by two sideplates. Vanes or blades fit within the slots of the impeller. As the rotor rotates (yellow arrow) and fluid enters the pump, centrifugal force, hydraulic pressure, and/or pushrods push the vanes to the walls of the housing. The tight seal among the vanes, rotor, cam, and sideplate is the key to the good suction characteristics common to the vane pumping principle.

2. The housing and cam force fluid into the pumping chamber through holes in the cam (small red arrow on the bottom of the pump). Fluid enters the pockets created by the vanes, rotor, cam, and sideplate.

3. As the rotor continues around, the vanes sweep the fluid to the opposite side of the crescent where it is squeezed through discharge holes of the cam as the vane approaches the point of the crescent (small red arrow on the side of the pump). Fluid then exits the discharge port.


· Aerosol and Propellants

· Aviation Service - Fuel Transfer, Deicing

· Auto Industry - Fuels, Lubes, Refrigeration Coolants

· Bulk Transfer of LPG and NH3

· LPG Cylinder Filling

· Alcohols

· Refrigeration - Freons, Ammonia

· Solvents

· Aqueous solutions

For further Technical details or Inquiries mail to or visit

5R / 4 Gobind Bhawan, , New Industrial Town, , Faridabad, Haryana 121001, India

098180 79220

©2017 by JSD ENGINEERING PRODUCTS. Proudly created with